calibration-standards Downloads
8 downloads found
It is widely used in different kinds of mask breathing valve punching. Pedal type control, easy to operate. Richpeace independently developed control system and SMC brand cylinder combination to ensure stable operation of the equipment. The punching is stable and reliable. The whole welded steel frame is firm and stable, the design is compact and simple, and and the wheel design is convenient in ...
N.E.T. CYBER TTL is a microprocessor driven electronic interface to turn any gas sensor in a legitimate detector, with voltage and digital (TTL) output, contacts for fault and alarms. It fits virtually any technology of gas sensing device with standard 4- or 7-series built, will sample and process signals from it, linearize it and compute it in a standard voltage and digital Modbus TTL output. ...
ByNET Srl
The Dual Geometry “S” vial standard is the only direct NIST (National Institute of Standards and Technology) traceable dose calibrator standard for Ga-68 and F-18 available. The patented design provides you with the capability of calibration in the traditional vial or in the needed syringe position for your dose calibrator. Both the 0.5 millicuries (18.5 MBq) and 1.0 millicurie (37 ...
QuickLung® is an adjustable, precision test lung for ventilator testing and training. It is compact, easy-to-use, and capable of simulating a wide range of patient conditions, including patient inspiratory efforts. QuickLung is available in a an adult or pediatric model, both in calibrated or standard versions. Learn more in the “Options” section below. You can use QuickLung ...
Platinum RTD sen-sors have built-in DIN standard calibration curves that have been extended to 14K for cryogenic use. ...
The dried eluate was reconstituted with 900 µL (2x 450 µL) 10 mM ammonium formate. The internal standard mix (100 µL) was then added to give a final concentration of 1.0 ppb. Matrix-matched calibration standards were prepared with the same protocol with the exception of the final eluate, which was reconstituted in 800 µL (2x 400 µL) 10 mM ...
Press “calibrate” button.The ultrasonic sensor (fill to volume) should not need to be recalibrated after the initial installation unless the customer wishes to increase the precision and accuracy for a final volume different than the current calibration, if the arm is removed, or if changing to a different brand of tubes.The following image displays typical ...
Press “calibrate” button.The ultrasonic sensor (fill to volume) should not need to be recalibrated after the initial installation unless the customer wishes to increase the precision and accuracy for a final volume different than the current calibration, if the arm is removed, or if changing to a different brand of tubes.The following image displays typical ...