- Home
- Applications
- rwanda
- process gas
Show results for
Refine by
Process Gas Product Applications Available In Rwanda
19 applications found
Process Information: SO3 gas is used in a sulphonation reaction process. Fibre filters which are installed before the sulphonation reactor remove very fine oleum mists. The SO3 gas (6-7%) can contain up to 7,000 mg/m³ of oleum mists, and due to the highly exothermic reaction, it is normal to trace heat and insulate the vessel to prevent oleum ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Process Information: Hydrochloric Acid can be emitted from many industrial processes, where it is either used in that form, or generated from the process. HCl will usually be in fine, sub-micron mist form. The gas comes from the process or vapours are drawn to the chimney by a suction fan. Example: In a PVC processes the VCM gas is condensed and the liquid is then fed to a reactor, before passing ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
The freeze drying process is optimised by the introduction of solvents and gas species to improve product quality and to enhance the drying process. Hiden's gas analysers provide detailed information about the gas/vapour composition during both the primary and secondary drying phases. ...
ByHiden Analytical Ltd. based in Warrington, UNITED KINGDOM
Claus Catalyst Zibo Xiangrun and Shandong Bairui Professionally produce and supply claus catalyst and sulfur recovery catalyst. Sulfur recovery refers to a gas desulfurizing process, or Claus process, which recovers elemental sulfur from gaseous ...
ByZibo Xiangrun Environmental Engineering Co., LTD. based in Zibo City, CHINA
Such applications are frequently found in Oil & Gas processing. For more details on these applications see “Corrosive Engineering” Additionally duplex is specified instead of 316 SS in applications which are both corrosive and abrasive because duplex is tougher and more robust than 316 Stainless Steel. ...
ByLobePro, Inc. based in Brunswick, GEORGIA (US) (USA)
ByAMETEK Process Instruments based in Pittsburgh, PENNSYLVANIA (USA)
Process Information: SO3 gas is used in a sulphonation reaction process. ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Process monitoring in the petrochemical industry. Monitoring of syngas and other gas processes for safety, quality assurance and process optimization. ...
ByIonicon Analytik Ges.m.b.H. based in Innsbruck, AUSTRIA
Tail Gas Scrubber Process Information: The SO2 conversion rate of single absorption plants is lower than double absorption, and many single absorption plants installed tail gas scrubbers to reduce this SO2 content rather than convert the plant to double absorption. Scrubbing the tail gas (tail gas scrubbing) to acceptable SO2 emission values can be done with seawater, caustic, lime slurry, hydrogen peroxide or ammonia. After ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Tesla Disk Pumps deliver smooth, non-agitating flow for delicate compounds, solvents, coatings, and bio-based materials—without shear, foaming, or ...
ByTesla Disk Pumps based in El Dorado, ARKANSAS (USA)
atea has extensive experience in the development and modeling of industrial chemical processes. For this we use both commercial process simulation programs as well as special own calculation routines. ...
ByHürner Luft- und Umwelttechnik GmbH based in Ransbach-Baumbach, GERMANY
USP37 Medical Gas requires a specific, selective and positive identification test using a paramagnetic signal. Regular analysis of medical gas is required to ensure that the oxygen concentration is NLT 99.0% volume. Following the appropriate United States Pharmacopeia standards, in this case specifically USP37, requires an analyzer which uses a paramagnetic based technology. The Systech Illinois Paramagnetic Oxgyen Analyzer PM700 is perfectly suited for this medical gas analysis ...
ByIndustrial Physics Product Integrity Limited based in Thame, UNITED KINGDOM
Process Information: Hydrochloric Acid can be emitted from many industrial processes, where it is either used in that form, stored with tank ventilation, or generated from the process. HCl will usually be in fine, sub-micron mist form. The gas comes from the process or vapours are drawn from the tank into a scrubber by a suction ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Process Information: Hydrochloric Acid can be emitted from many industrial processes, where it is either used in that form or generated from the process. HCl will usually be in fine, sub-micron mist form. The gas comes from the process and vapours are drawn into a scrubber by a suction fan. Titanium Dioxide Chloride process – emissions of TiO2 dust and HCl ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Process Information: Hydrochloric Acid can be emitted from many industrial processes, where it is either used in that form, stored with tank ventilation, or generated from the process. HCl will usually be in fine, sub-micron mist form. The gas comes from the process or vapours are drawn from the tank into a scrubber by a suction fan. Pharmaceutical plant - general process vent emissions of ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
Process Information: Hydrochloric Acid can be emitted from many industrial processes, where it is either used in that form, or generated from the process. HCl will usually be in fine, sub-micron mist form. The gas comes from the process or vapours are drawn to the chimney by a suction fan. In a Titanium Dioxide Chloride process there are emissions of TiO2 dust along with HCl, and after one or more ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM
ByKimre Inc. based in Homestead, FLORIDA (USA)
ByAMETEK Process Instruments based in Pittsburgh, PENNSYLVANIA (USA)
Phosphor Bronze Processing – Phosphoric Acid / P2O5 Filtration Systems. Process Information: Phosphorous is injected into a bath of molten copper, to produce Phosphor Copper metal. There is then a fume produced from the reaction in the bath, which is extracted by a fan to a filter system, before the cleaned air is then emitted to atmosphere. P2O5 mists are entrained with the fume, and frequently carbon solids are entrained also. (The origin & nature of the Phosphorous is a major factor in the quantity of ...
ByBegg Cousland Envirotec Limited based in Glasgow, UNITED KINGDOM